[Shotimes] Air intake couplers, anyone know of a good place?

[Bruce Malachuk]

I'm in the process of getting my 80mm MAF in place. I have an adapter for the
MAF on the inlet side that should work fine mated up to the stock airbox lid.
I was planning on using a piece of SS exhaust pipe for the run from the end of
the MAF to the TB. Was gonna stay with the 3.5in diameter that the MAF lets
out with all the way up to the TB.

I know that I can spend $42 for a 3.5in to 3in reducing coupler in silicone #
F2HZ-6C640-G from Ford. But being the cheap bastard that I am I'd love to find
another cheaper source. I've been looking around the home depot and I'm not
sold on anything there. Specifically because there is no give in any of the
plumbing connectors. I want something that will give a little as the engine
moves around the very little that it does (thanks to kirk's mounts) and I'm
not going the clothes dryer duct route.

What I want doesn't even have to be silicone, plain old rubber couplers would
do fine too. I'm searching around the net, but haven't found anything good
yet. If anyone knows of a place that I should look please let me know

Bruce
94 Opal Frost MTX
94 Deep Emerald Green ATX - w/90k gonna be parted