[Shotimes] TPS Fault Code

[Ron Childs]

You could check to see if the voltage at the TPS is in range. I think the output is the center of the three wires (not sure of the color.) With key on, engine off, look for just under one volt with the throttle closed and five volts at WOT.
 
-Ron Childs   '91


Jacob Cassidy <jcassidy1@hot.rr.com> wrote:
I got the good ole CE light this week. Checked the KOEO test and it came
back as TPS out of range parameters. KOER yields the same result. So I
went and got a new one from O'Reilly's and it seemed to be doing fine
until the engine really warmed up. Then the CE light came back on while
running 70 mph or so down the road. I got it home and KOEO read TPS out
of range parameters again. Any clue what is still causing this? I've
checked for vacuum leaks and made sure all hose connections were good.
Other than that I am at a loss. 

Jacob Cassidy
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes