[Shotimes] 93-95 console
Ian Fisher
dataflash@yahoo.com
Mon, 12 Jul 2004 18:04:51 -0700 (PDT)
There is a bracket there and IIRC it's part of the
floorpan so you can't really swap them without
welding.
Ian
--- van Oss <vanOss@centurytel.net> wrote:
> My 91 is now sporting a 93-95 center console. The
> top panel was for an ATX,
> with the narrow, rectangular opening for the ATX
> floor shifter. To
> accomodate my MTX rod shifter, I enlarged the
> opening with my hand router.
> Fortunately, there's a plastic lip molded in that
> makes a nice edge, so you
> can enlarge the opening about 3/8" on each side.
> This is enough to clear
> all gears. When I can get a new shift boot, I'll
> fasten it on the underside
> of the panel using the metal trim ring that held on
> the ATX rubber boot.
>
> Thanks Bruce M. for sending mounting brackets. It
> turned out that the rear
> bracket needed two holes drilled (Gen2 bracket had 3
> holes, Gen1 floor has 2
> studs for which I had to drill 2 new holes). Bruce
> sent me a second bracket
> that is the same as the front bracket (forward of
> the shifter) as already
> bolted into my 91. I do not see how this bracket
> has any use with a 93-95
> console. Finally, it appears the 93-95 console
> expects a center bracket
> (just aft of the shifter) that (I infer) bolts to
> the floor and accepts a
> screw down through the bottom of the cupholder. I
> do not have this center
> bracket.
>
> Can anyone with a factory 93-95 console (Al, are you
> listening) confirm my
> guess that the 93-95 console requires a center
> bracket, just aft of the
> shifter? I'd be grateful for a photo if this is
> correct.
>
> VO
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
>
__________________________________
Do you Yahoo!?
Yahoo! Mail is new and improved - Check it out!
http://promotions.yahoo.com/new_mail