[Shotimes] Tach signal?

[James F. Ryan III]

Bruce,

There is a "Tach Service Connector" in the engine compartment by the
passenger side strut tower.  It has a small gray connector and it's a gray
wire with an orange stripe.  (It should be hanging somewhere near the "EEC
test connector")  That's your "tach out" connection, so all you need is +12V
from the headlight circuit and a ground.

Jim


----- Original Message ----- 
From: "Bruce Malachuk" <bmalach1@nycap.rr.com>
To: <shotimes@autox.team.net>; <TechSHO@topica.com>
Sent: Friday, October 22, 2004 10:20 PM
Subject: [Shotimes] Tach signal?


> annyone out there know what wire I should be hooking up to off the DIS or
> coil to get a tach signal for my Autometer RPM module for a mini-shift
> light? Talked to autometer today, the guy said there should be a tach
pickup
> connector on the firewall, but I don't believe there is. I figured that Ii
> would have to tap into a wire on the DIS harness or off the coil pack. One
> would assume that the same wires for hooking up a monster tach would be
the
> same for hooking up this RPM module. Not saying that that many here would
> have a monster tach.
>
> thanks
>
> Bruce Malachuk
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes