[Shotimes] Help with engine stumble in 95 MTX

[Jim & Debbie Leyden]

I believe it is 24 tooth and 48 tooth

Jim



-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of George Fourchy
Sent: Wednesday, August 10, 2005 12:07 PM
To: shotimes@autox.team.net
Subject: RE: [Shotimes] Help with engine stumble in 95 MTX

On Wed, 10 Aug 2005 08:58:39 -0700 (PDT), Ian Fisher wrote:

>On the SHO, the intake cams can only be adjusted
>independently using adjustable sprockets such as
>Josh's timing chain sprockets.

Theoretically, if someone wanted to spend a bunch of money to buy those
sprockets, I
suppose one could.

But if you divide the number of teeth in the factory sprockets by 360,
you'll get
the number of degrees either side of TDC one tooth will give.  I don't have
any
right here...they are in storage, but if there were 90 teeth, each one would
be 4
degrees.  If there were 60 (probably closer to correct), then each would be
6
degrees.  If the crank sprocket has 30, then each one would be 12, probably
a bit
much for a slight valve timing exercise.

...that sounds about right....30 teeth on the small sprocket, and twice as
much for
half the speed...60 on the bigger sprocket.....

Count the teeth, then adjust the cam sprockets by as many degrees as you
want to
try.

George
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes

-- 
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.5/67 - Release Date: 8/9/2005
 

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.338 / Virus Database: 267.10.5/67 - Release Date: 8/9/2005