[Shotimes] Bad Ball Joints or Wheel Bearings?
Ian Fisher
dataflash@yahoo.com
Fri, 4 Nov 2005 04:33:02 -0800 (PST)
If you are running the thick slicer hats with longer
studs, expect to run through wheel bearings somewhat
frequently. For me, that's reason #542 to get thinner
hats and thicker rotors and dump my slicers forever.
It's a good idea if you have ample spoke to caliper
clearance with your rims.
Ian
--- George Fourchy <krazgeo@comcast.net> wrote:
> That was immediately after I had
> the bearing replaced when the old one had about an
> inch of play. These were (still
> are) Scott Chan's Wilwood knuckles that were new
> from TCE in about 1996 or so. That
> was the left side....the right side is still
> original, and at last check (2004) had
> hardly any measurable play.
>
__________________________________
Yahoo! Mail - PC Magazine Editors' Choice 2005
http://mail.yahoo.com