[Shotimes] Replacing Brake Hose / Touch Up Paint?

[Paul Nimz]

You will also need a 2 new copper washers for the banjo bolt if they did not
come with the new hose.

Paul



On 4/5/2006 11:28:38 PM, Chris Riedl (zap@columbus.rr.com) wrote:
> Thanks to
> Jim's suggestion, I got the endlink properly installed,
> however the real problem is the rear brake hose that I went to
> replace.  I understand how everything is supposed to work, except for
> where it attaches to the brake line.  The junction is incredibly
> rusty, so I soaked it a few times in PB Blaster.  What is the easiest
> way to get this apart, and should I have gotten a second clip for the
> line side?  I know that the line must be bad, since it isn't
> fully
> releasing the caliper, and when I wiggle it around a bit, the caliper
> releases the rest of the way!
>
>
> Also, any leads (dealer? or?) on a small jar/can of touch up paint
> would be nice.  Someone decided to put a scratch in my door that
> should probably be covered over.  I know that I've seen them
> somewhere, and I need an Emerald Green one.
>
> Thanks,
> -Chris
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes