>
> I just replaced thhe master cylinder on my 62 alpine and rebuilt the slave
> yet I must repeatedly pump the cluth on order to accumulate enough presure to
> disengage the clutch.
> Any ideas befor I replace the slave too would be appreciated.
>
> Eric
Sounds like you haven't gotten all the air out. Rebleed the system.
Also check to make sure the slave isn't installed incorrectly. It's
kinda embarrassing to admit but I installed the slave upside down on
my snake. This put the bleeder valve below the inlet line making it
nearly impossible to bleed all the air out.
Roland
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:18:48 CDT