> If you can't find one, you can get one made at any decent Marine
>Supplier. I had a custom throttle and choke cable made for my 65 Imp
>when I switched over to 4, 22mm Kehin Carbs (They were off of a 76 Honda
>550 Super Sport). It worked great. I soldered the ends and cut the
>cable to the length I needed. Wasn't too big a deal. Marine shops have
>this stuff in bulk spools for Boat control cables...
>
>Rich
>
When soldering cables, please keep in mind that you must "bend the steel
wires wide open" before soldering. After that you just work the joint neat
with a fine file.
This is a routine (?) job for motor bikers. It is described in almost all
DIY books.
If you dont forge the cable wires open, one day the solder joint traits
you. If it is a brake cable, ...
Larry
Helsinki calling
AJS 1952 & 1960, Sunbeam Alp SIV 1964
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:36:18 CDT