On Sat, 20 Sep 1997 17:14:46, -0500 GDWF22A(at)prodigy.com (MR RICHARD T
TRENK SR) writes:
>Jarrid mentioned that you needed to have a certain data on the wrist
>pin >(gudgeon pin in limey talk) dia. but this is not required. The
>"compression height" which as Jarrid quoted, is from wrist pin
>CENTER to TOP of piston crown is of course the key thing.
Somebody DOES have to machine the grudgeon pin hole in that
piston now dont they?
Iffen so, it would probably be good to know what size hole to put in
there?
Jarrid
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:57:06 CDT