SOLers,
I am in need of oversized piston pins for the engine rebuild on the
Sunbeam Talbot 2267cc engine due to an error by the machine shop fitting
the pistons to the rods. The pins removed from the new piston set are 24mm
(.945") diameter by 69.07mm (2.719") in length. The oversized pins required
would be the same length but with a diameter of .946".
Does anyone know of a source of oversized pins? If this diameter is not
readily available (which I doubt), does anyone have experience with a
machine shop that has a centreless grinder that could take a larger
diameter pin and
make them the required size?
Thanks,
Bob
=========================================================
Robert (Bob) A.C. Hamilton, Waverley, Nova Scotia, Canada
The Man of Many Sunbeams - Alpine, Drophead and Saloon 1953-1954
Home Page: http://cast.navnet.net/~hamilton/index.html
E-Mail: hamilton(at)cast.navnet.net
=========================================================
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:57:40 CDT