From: joe kleifges
>i need to know the max bore i can have with stock pistons.
> i have a set of extra standard bore pistons, and a block with stock
>bores that will need a heavy hone to get the bores in shape. i think
they
>will clean up well at .003-.005 over.
> will this work, or is a .020 over bore and pistons in order. i don't
>plan to beat on this engine, when built, if that means anything. if
this
>is doable, will there be a need for special rings??? or other mods to
>make it work right??
Over bore pistons and rings are available in .020, .030 and .040.
If you are going to slap sloppy pistons on the cleaned up bores,
use the next ring up, and file to the correct gap.
Be prepared for a lot of piston slap and noise.
Ive seen people run new rings in engines with clearances as sloppy
as .010.
Sounds like a thrashing machine cold, but doesnt seem to hurt
oil consumption too much.
Jarrid
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:28 CDT