You wrote:
>
>I don't mind a little oil drippage but enough is enough. In an
attempt to
>stop the bleeding, I'm replacing the cork gasket on the pushrod
inspection
>plate. Should the screws have thread sealer applied to them on
replacement?
>If so, how much and what kind? Will it stand up to the heat?
>
>James (in a puddle o' crude)
>SII B9119860 OD LRX
>
>
I use silicon on the plate - plenty of it and no gasket. Check that the
bolts havn't distorted the plate. Thjey tend to if really tightened. If
so straighten it out. No sealer on the bolts.
John
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:37 CDT