John Souders wrote:
>
> You wrote:
> >
> >I don't mind a little oil drippage but enough is enough. In an
> attempt to
> >stop the bleeding, I'm replacing the cork gasket on the pushrod
> inspection
> >plate. Should the screws have thread sealer applied to them on
> replacement?
> >If so, how much and what kind? Will it stand up to the heat?
> >
> >James (in a puddle o' crude)
> >SII B9119860 OD LRX
> >
> >
> I use silicon on the plate - plenty of it and no gasket. Check that the
> bolts havn't distorted the plate. Thjey tend to if really tightened. If
> so straighten it out. No sealer on the bolts.
>
> John
So, how do we stop the bleedin in our plug-oles !
Tony
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:37 CDT