Re: rocker covers

• Next message: rootes(at)ix.netcom.com: "Looking for Webber carbs"
• Previous message: jarrid_gross(at)juno.com: "Re: rocker covers"
• In reply to: jarrid_gross(at)juno.com: "Re: rocker covers"
• Next in thread: Ron Tebo: "Re: rocker covers"
• Reply: Ron Tebo: "Re: rocker covers"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

> On Thu, 27 Nov 1997 03:15:08 -0700 jerome(at)supernet.ab.ca (Jerome Yuzyk)
> writes:
>
> >I have two different rocker covers to choose from, both aluminum. One
> >has the SUNBEAM lettering at the front end and no place for the

Many thanks for the blizzard of responses.

Now that I know the unstamped cover is not a big deal, I want to
customize it. I'd like to cut a "TOMATO" into the rectangle, a stylized
tomato into the diamond, and paint the raised areas red.

How to carve aluminum? Would sand-blasting over a rubber mask work? Do I
finally have a reason to buy a Dremel kit?

-- 
-              J e r o m e   Y u z y k | jerome(at)supernet.ab.ca          -
-           BRIDGE Scientific Services | www.tgx.com/bridge             -
-    Sunbeam Alpine Series II #9118636 | www.tgx.com/bridge/sunbeam     -

• Next message: rootes(at)ix.netcom.com: "Looking for Webber carbs"
• Previous message: jarrid_gross(at)juno.com: "Re: rocker covers"
• In reply to: jarrid_gross(at)juno.com: "Re: rocker covers"
• Next in thread: Ron Tebo: "Re: rocker covers"
• Reply: Ron Tebo: "Re: rocker covers"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:58 CDT