Tony Leeming wrote:
> I need some assistance. I have had the slave cylinder re-sleeved and I
> re-assembled it on the car today
> ( bleed screw topside!!) I filled the slave with fluid. I cannot get the air
> out of the system. I can't even get fluid out of the end of the master
> cylinder when I disconnect the pipe...only air. The piston in the master is
> moving back and forth with the pedal.
> What do I do next?
> Tony
Tony:
You don't say whether you had the master cylinder apart. Also, what is
happening to the fluid in the reservoir? I would suspect that the inlet port of
your reservoir was plugged if the fluid did not go down when pumped before
re-assembly. Even if the line was plugged, fluid entering from the reservoir
would displace any obstruction or give a firm pedal. If you had the master
cylinder apart and checked this, then the only thing I couldthink of was that
the main cup must be in backwards.
Ron Tebo
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:26:47 CDT