Bob,
I had planned on doing this. Smitty was supposed to get me a set of
those spindles, but they never materialized. He gave me a set of
Hunter springs instead, which he said would lower the front about an
inch. The spring rate for Hunter springs is far too low, however, so I
am going to put in some Tiger springs. It is my understanding (could
be wrong) that Tiger springs are slightly shorter than Alpine springs,
though I'm not sure how much (if at all). I am interested in the
spindles if you get a line on a supplier. Please let me know.
Christopher
herbeam(at)cari.net writes:
>Does anybody have anything to add to the thread I tried to start about
>lowering your Alpine/TIger front suspension without losing any
>suspension
>travel ? Am I the only one in the world who lowered his Alpine using
>Hillman
>spindles ? Does anybody else have any of these spindles? I wrote to
>Grimes
>in London and they don't have any spindles available. For those of you
>who
>missed my post::
> The spindles I am talking about came off a 60's Hillman that had 15"
>wheels. The axles are forged 1" above the lower ball joint mount. The
>part
>number stamped on the spindles is
> 1990445 17230 LS & RS (right side). Also is EN6CGS6-S J4S8.
>Does anybody out there have any ? I would like to obtain another set. I
>have images upon demand.
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:29:03 CDT