Re: RE: RE: Clutch work

From: Christopher Albers (Christopher.Albers(at)bubbs.biola.edu)
Date: Thu Aug 12 1999 - 13:38:19 CDT

Next message: Steve Shuttleton: "Introduction"
Previous message: Brent kasl: "Re: tow tip needed"
In reply to: Jarrid Gross: "RE: RE: Clutch work"
Next in thread: Tony Leeming: "Re: RE: Clutch work"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

JGross(at)econolite.com writes:
>My advice is that if you are going to the trouble to remove the
>transmision to replace the TO with the roller unit, why not go the
>extra mile and put on the correct fulcrum piece?

So I need an early series fulcrum? Will a roller bearing fit on that?

CNA

Next message: Steve Shuttleton: "Introduction"
Previous message: Brent kasl: "Re: tow tip needed"
In reply to: Jarrid Gross: "RE: RE: Clutch work"
Next in thread: Tony Leeming: "Re: RE: Clutch work"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 11:00:45 CDT