A good thing to look for.
Some rebuild kits out there are actually meant for the 150CDSE, which has a
slightly differently shaped bowl. Applied to the 150CD, one corner will not
seal.
Dick Sanders
Seattle
In a message dated 11/21/1999 9:12:24 AM Pacific Standard Time,
iwander(at)att.net writes:
<< This was a problem on carbs I rebuilt for a friend. It also leaked gas at
the carbs......seems that the level of the gas is at a higher point than
the bowl seem/gasket. This may be due to the fact that the carbs are at an
inclined position. You might take a look at the bowl gasket. I remember
that it will fit in two positions......both of which match the body of the
carb but only one will match the outline of the bowl. I suggest matchiung
the gasket to the bowl first before intstallation.
Sergio
1967 Sunbeam Alpine
Series V 'AJNT 86'
still working on it but getting closer (yea right!)
>>
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:41:53 CDT