In a message dated 3/18/2000 4:06:36 PM Pacific Standard Time,
dougbilesky(at)home.com writes:
<< I have removed the gearbox without the engine.
I unbolted the tail pipe from the manifold.
I removed the downpipe where the oil is added to the rocker cover( up top
close to the firewall).
This allowed for enough room for the engine to tilt.
I too have an OD and was able to drop gearbox to do my clutch. >>
Its also a good idea to loosen the motor mount bolts to give the engine a bit
more room to tilt and lessen the stress on the mounts.
Removing both the engine & tranny together might be easier, but if you don't
have an engine hoist on hand.....
Dick Sanders
Seattle
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:52:41 CDT