John, I am using two T03 units from 85 T-bird. I have done enough
calculations that show at a pressure ratio of 2 (1 atmosphere boost) these
will suffice to about 6500 rpm and at B'ville altitude. With the chosen
cam 226/210 ls 110 and compression at 8.5 all may calcs say about 650 hp.
Will be using World Products Senior Al heads (maybe trick flow but I hear
they have valve guide problems). I will have one TB hooked up and One MAF
but running large injectors > 55lbs/hr. Planning on SpeedBrain for ECU so
will have complete data logging and mod capability. As to wheels, no I do
not want steel wheels, I want alloy. I plan on Weld Prostars for racing but
I need a couple of ?? just to put it on the ground so I can roll it around
better.
mayf
At 10:03 AM 10/7/99 -0400, John Beckett wrote:
>Wow, that got em stirred up. Might look into NASCAR type wheels for your
>project. I believe they make them with the proper bolt patern, diameter and
>back spacing. What type and size turbos are you using on your Alpine?
>
>At 04:10 PM 10/6/99, Lawrence E. & Cathy R. Mayfield wrote:
>>Too darn quiet on the list! What's going on? Everybody mad at each other?
>>Or what? Did my first TIG aluminum welding yesterday. What a hoot! Looked
>>like a bunch of angry chickens drizzled all over it. But today, a different
>>story! I cranked the amps up, polished the weld area with a scuff pad and
>>went at it. Most welds pretty good (oh, I am making my own twin throttle
>>body upper manifold for my twin turbo setup). I mean it looks homemade but
>>not too bad.
>>
>>I need some wheels for my car. I need something 10 inches wide with 5 on
>>4.5 stud spacing and 6 inch (5.5 ok) backspacing. These are just to get the
>>car on some rear tires so I can determine the shock mounting height, etc.
>>It's already on the front tires. Anybody on the list have anything they
>>might part with? Oh, they need to have the 11/16 stud holes, not tapered
>>nuts, because I am using Mark Williams 5/8 inch studs (HUGE).
>>
>>Well, this otta be nuf to start some conversation...especially my welding
>>expertise.
>>
>>mayf
>>
>>
>>
>>L.E. Mayfield
>>124 Maximillion Drive
>>Madison, Al. 35758-8171
>>1-256-837-1051
>>
>>http://www.hsv.tis.net/~mayfield
>>
>>DrMayf@AOL.com
>>lemay@hiwaay.net <<<<preferred
>>
>>
>>Bonneville Land Speed Racer, '66 Hydroplane Drag Boat (390 FE)
>>
>
>
>
>
L.E. Mayfield
124 Maximillion Drive
Madison, Al. 35758-8171
1-256-837-1051
http://www.hsv.tis.net/~mayfield
DrMayf@AOL.com
lemay@hiwaay.net <<<<preferred
Bonneville Land Speed Racer, '66 Hydroplane Drag Boat (390 FE)
|