Re: headers

[LGMCAFEE@aol.com]

In a message dated 2/5/02 1:42:35 PM Central Standard Time, kturk@ala.net 
writes:

<< Sounds a lot like my Cast Iron D motor....  and we have run a set of 1 3/4
 Schoenfeld's for the last 3 yrs with no real problems ... as a matter of
 fact we ran the C motor with Brownfeild heads on it with the same headers
 ... again no problems.  Now the question is would I make them bigger if I
 had the option and the answer is yes.... I'm liking the 1 7/8'ths to 2"
 deal if I could have bought them for my car...
  >>
Keith you would not go any smaller than 1 3/4 if I understand you right. I 
was thinking maybe the 1 5/8 dia or 1 3/4 about 30 inches long. I'll do what 
Doug said and call Schoenfeld tomorrow. Thanks Larry Mac

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed