[Top] [All Lists]

Was MGA Cooling, now Bezel Removal

To: <>
Subject: Was MGA Cooling, now Bezel Removal
From: "Edwin McCarroll" <>
Date: Fri, 15 Jun 2001 09:16:50 -0400
Received good advice from the list on how to recalibrate the temp. gauge to 
match thermometer readings vs. sender bulb unit.   Ultimately the advice said 
to remove the needle from the gauge face and remount it to indicate the 
temperature shown on the thermometer while immersed in a warmed up container of 
water.     I managed to remove the sender bulb unit from the block and 
proceeded to loosen the temp/oil press. gauge from the dash.   I am now stymied 
because no matter what I tried I could not rotate the bezel ring to remove it 
from the gauge.   It didn't budge an iota.   Any suggestions for accomplishing 
such a task?

/// mailing list
///  (If they are dupes, this trailer may also catch them.)

<Prev in Thread] Current Thread [Next in Thread>