[Top] [All Lists]

'70 new top install questions

To: "'MG List'" <>
Subject: '70 new top install questions
From: "davewillner" <>
Date: Fri, 1 Dec 2006 14:10:19 -0500
Reply-to: "davewillner" <>
Sender: owner-mgs@Autox.Team.Net
I just picked up a new top for my B and had a question, it's the original top
I'm replacing and not sure what the protocol is for this.  The rubber molding
strip has the mounting bracket riveted in place with the vinly tucked
underneath. Should I remove the rivets and maybe just replace it with sheet
metal screws after the top is cemented in and tucked under it?  Or should I
just leave it alone and cement up to it, any problems with that?

Appreciate the help

Dave Willner
Stroudsburg, PA
59 TR3A
70 MGB
70 BSA 441 Victor Special

Your messages not reaching the list?
Check out

===  Help keep Team.Net on the air

===  unsubscribe/change address requests to  or try
===  Other lists available at
===  Archives at
===  Edit your replies!

<Prev in Thread] Current Thread [Next in Thread>