oletrucks
[Top] [All Lists]

Re: [oletrucks] 350 starter- Thanks!

To: sculver@iwl.net, oletrucks@autox.team.net
Subject: Re: [oletrucks] 350 starter- Thanks!
From: Passnb4U@aol.com
Date: Sun, 30 Jul 2000 13:00:06 EDT
In a message dated 7/30/00 7:16:27 AM Pacific Daylight Time, sculver@iwl.net 
writes:

> Thanks, everyone, for the advice on the 350 starter.  Went to the local NAPA
>  dealership, bought an $80 starter with a high temp solenoid, and haven't 
had
>  a grinding problem since I put it on.  And I was going through the $15
>  starters at the rate of about 1 per week.
>  
>  I still have a question, however.  Although there is no grinding, when the
>  engine is hot, the sarter seems to drag a little.  Is this characteristic 
of
>  Chevys, or is there still a problem that I need to address.  It starts 
every
>  time, just a little slower to turn over after I've been driving awhile.
>  
>  Thanks!
>  
>  Smokey Culver
>  '50 3600 5-window (mine)
>  '58 Apache (hers)
>  League City, Texas


  Smokey,

  As mentioned before, make sure the timing is not too advanced, a few 
degrees will make a difference, I'd also add a heat sheild to the starter, 
and make sure the POS and NEG cables are clean and shiny where they contact 
everything as well as the lugs.  Make sure the cables have no corrosion in 
them too.

  BTW, those higher torque starters are the way to go.

  Mike
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>