oletrucks
[Top] [All Lists]

Re: [oletrucks] steering column

To: oletrucks@autox.team.net
Subject: Re: [oletrucks] steering column
From: New Mexico Jim <ADvent@thuntek.net>
Date: Mon, 04 Sep 2000 20:12:02 -0600
I'd like that, but at that heat, I think I would wait. I was complaining about
mid 80's, today.

Claude wrote:

> I guess I could measure the bolt holes and location of the shaft as it goes
> thru the frame or maybe make an impresion of the frame and scan it for you.
> I won't do this unless you really want it. It was 111 degrees today, too hot
> to be under the truck for too long.
>
> ----- Original Message -----
> From: "New Mexico Jim" <ADvent@thuntek.net>
> Cc: <oletrucks@autox.team.net>
> Sent: Monday, September 04, 2000 7:25 PM
> Subject: Re: [oletrucks] steering column
>
> > I hopw they will swap out. that would give me 4 less inches of column with
> no
> > cutting. thanks.
> >
> >
> > Claude wrote:
> >
> > > I have the column out of my '59 and measured it. From the box where the
> > > column is attached to end point of the shaft is 36". to the bottom of
> the
> > > splines is 34 3/4". to the top of the splines is 35 1/4". The steering
> wheel
> > > is 5 1/4" deep from the top of the wheel to the bottom of the
> splines.(as it
> > > lays on the bench without the bottom cone). hope those measurements make
> > > sense.
> > > I have no idea if they will bolt up.........
> > > Claude
> > > 1959 Apache Fleetside
> > > http://www.dashlink.com/~rameyfam
> > >
> > > ----- Original Message -----
> > > From: "New Mexico Jim" <ADvent@thuntek.net>
> > > Cc: <oletrucks@autox.team.net>
> > > Sent: Monday, September 04, 2000 4:37 PM
> > > Subject: [oletrucks] steering column
> > >
> > > >
> > > >
> > > > Will somebody who has a 57 to 59 truck measure th steering column from
> > > > where the tube goes into the box and to end of the column? My 57 had a
> > > > dished wheel, because the columns were shorter in that year that they
> were
> > > > in 55 or 56. Those had a flat wheel. Will a steering box from a TF
> bolt up
> > > > to the frame correctly on an AD?
> > > >
> > > > oletrucks is devoted to Chevy and GM trucks built between 1941 and
> 1959
> > > >
> > >
> > > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
> >
>
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>