looks to me like mount holes for some type of badging used previously.
my 2 cents....
Tom Di Iulio
1976 TR6
Denver, Co
----- Original Message -----
From: "Ronald A. Dowty" <rdowty@dowtyenterprises.com>
To: <6pack@autox.team.net>
Sent: Sunday, December 29, 2002 6:20 PM
Subject: Can you explain these holes?
> I was stripping down my drivers side door panel and noticed a there was
> something a little different going on in the lower forward section of
> the door. To my suprise I found for holes that had some sort of plastic
> anchor left in it. Apparrently these were sanded flush and bondo'd and
> painted over by the DPO. I have no ide why the holes were there. there
> doesn't appear to be any signs of a dent being pulled out. The area
> around the holes is rather flat'ish though. Probably the bondo was used
> to round the area out a bit. I'm totally dumbfounded at what these are
> for. I don't think there were any factory emblems there. Anybody have
> any ideas?
>
> Follow link below for a picture.
> http://www.dowtyenterprises.com/images/DCP_0544.JPG
|
