buick-rover-v8
[Top] [All Lists]

RE: Torque settings for Rover exhaust manifolds

To: "'Jim Stuart'" <jimbb88@erols.com>, <lmg@gomog.com>
Subject: RE: Torque settings for Rover exhaust manifolds
From: "Bown" <Bown@concentric.net>
Date: Sun, 29 Oct 2000 21:35:28 -0700
Would you be so kind as to post the Felpro and Victor numbers for the
exhaust manifold gaskets.  (The kids running the parts counter at my local
auto-parts house aren't too bright)
Regards,
Jim B.

-----Original Message-----
From:   owner-buick-rover-v8@autox.team.net
[mailto:owner-buick-rover-v8@autox.team.net] On Behalf Of Jim Stuart
Sent:   Tuesday, October 17, 2000 7:30 PM
To:     lmg@gomog.com
Cc:     buick-rover-v8@autox.team.net
Subject:        Re: Torque settings for Rover exhaust manifolds

As I said, My shop manual is silent regards gaskets. This manual is part #
AKM 3616B copyright 1981. The parts manual is part # RTC9852CA dated January
1980. Since it shows the gasket as #GEG692, manifold to cylinder head, part
of gasket kit RTC2576 on both the section illustration of the exhaust
manifold, pg 1D 08, & also in the illustration of the gasket set mentioned,
pg 1D 14, I must assume that is was used in assembling the engine
originally, It is not noted as a later or modified part.

I was not aware of any GM engines being built without exhaust gaskets, as
all my parts books from Felpro & Victor, etc show a listing.

My personal opinion is that not using gaskets will result in leaks that are
unpleasant at best.

Jim Stuart

lmg@gomog.com wrote:

> Hi Jim and Paul,
>
> Jim, you and I have curiously different materiel to consult. I have
> opened up a number of SD1s and Vitesses. I have never found a set of
> gaskets on either manifolds or heddars. The shop manual and the Haynes
> manual both warn of cleaning the surfaces after removal "as no gasket is
> used between the two parts" p.62  Rover 3500 1976 to 1987.
>
> As Paul states, it is now recommended that exhaust gaskets be used and
> there are those made specifically for the engine. I change mine whenever
> I remove my heddars. Considering the caution of dealing with an aluminum
> block I would avoid lock washers and go for the flanges made
> specifically for this. There are also stainless exhaust bolts made for
> the V8s as well.
>
> Lorne



<Prev in Thread] Current Thread [Next in Thread>