I also looked for some pics but couldn't find any. They are mounted on the
head bolts, one on the driver side rear and the other on the driver side
front. The front eyelet is straight, while the rear one is bent at a 90
degree angle.
Andrew Murphy
SoCalROC
From: John Hogan <mad@madgrizzle.com>
Reply-To: John Hogan <mad@madgrizzle.com>
To: datsun-roadsters@autox.team.net
Subject: Re: Engine lifting points
Date: Sat, 02 Feb 2002 19:31:41 -0500
Ah.. well, apparently the answer is no. :) So its a couple of bolt on
eyelets, eh? Well.. the hooks for the engine tilter are actually L-shaped
brackets with a bolt hole on the vertical and horizontal parts of the L. I
could bolt it to the engine then. Which bolt hole would the eyelets be
attached to? I could see if I can bolt my L-brackets to them.
Thanks
John
At 03:53 PM 2/2/02 -0800, you wrote:
>John,
>
>Are the lifting eyelets in place? There are two metal eyelets located at
>the front and rear of the head that stick up and allow for the balancer
>chains to go through.
>
>They are also installed on my 1500 engine as well.
>
>Andrew Murphy
>SoCalROC
John Hogan
1967.5 Datsun 2000 SRL311-00141 "Solex"
SEROC
/// datsun-roadsters@autox.team.net mailing list
_________________________________________________________________
/// datsun-roadsters@autox.team.net mailing list
|