I am not sure about this, but my backing plate is out in the
garage next
to the engine, I can measure its thickness with my trusty
machinist rule, if that will be accurate engough.
Jim
Chesapeake Va
----- Original Message -----
From: datsunmike
Sent: Wednesday, April 17, 2002 6:53 PM
To: Greg Hare; datsun-roadsters@autox.team.net
Subject: Re: 1600 5 speed swap?
I was told that you need the backing plate from a 2L which is thicker than
the 1600 plate. Although I did use that plate before being told it made
sense when it was explained to me. Seems the front input shaft of the 5
speed is slightly longer than the 4 speed and to prevent the shaft from
bottoming out in the crankshaft.
Mike
----- Original Message -----
From: "Greg Hare" <ghare@bellsouth.net>
To: <datsun-roadsters@autox.team.net>
Sent: Wednesday, April 17, 2002 8:14 AM
Subject: 1600 5 speed swap?
> I have an opportunity to get a 5-speed roadster tranny (haven't had the
> chance to look at it yet & confirm as the person who has it now isn't SURE
> if it's 5 or 4 - just knows it's a roadster tranny) - what else is
required
> to swap this other than driveshaft & tranny mount? I have a 69 1600.
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
Web. FREE MSN Explorer download : http://explorer.msn.com
/// datsun-roadsters@autox.team.net mailing list
|