I received a picture of the head - the crack is to the point where if
it grows any further there will be definite sealing issues on #2 and
probably #3. I like this suggestion - a hole to stop the propagation
and silver solder to seal it back up. I'll have to remember that one!
When I went through the "cracked head" issue (mine wasn't
repairable), someone suggested "stitching" which is a series of
threaded plugs run through the crack. That's the only other fix that
comes to mind.
Cheers, Tony Drews
At 05:53 AM 12/24/2014, MadMarx wrote:
>You can stop the crack with a hole at its end and solder the crack with
>Seems to work fine with a good success rate.