Simon,
I just took my hand brake apart for de-rusting, cleaning etc. I take it
you know the adjusting method as per the driver's manual and/or the
workshop manual, but you want more. At the axle side the cable ends in a
piece of threaded rod which is connected to the cable. Don't try to
rotate this as the cable will rotate as well but can't because it is
held at the hand brake lever end.. On the threaded rod a fork is screwed
with a locknut, and the fork is attached to the balance lever with a
clevis pin. Undo the clevis pin, take the fork out of the balance lever,
try to unlock the locknut (good luck!) and try to turn the fork in
relation to the threaded rod. Again good luck to you - I had the cable
on my workbench in a vice and just managed to get the parts separated.
Use a lot of WD40 or similar goo. Replacing the cable is a rather nasty
job as there's a lot in the way, like a prop shaft. If you can undo the
prop shaft it shouldn't be too difficult. Otherwise you're welcome at my
place - I have a car lift making this job a lot easier. Maybe you can
find a car lift or a friendly garage a bit closer to home? I wish you
luck and success - and keep the First Aid kit handy!
Jack Aeckerlin, The Netherlands
1964 BJ8 29432
Simon Lachlan wrote:
>Okay, okay..emergency brake in some parts.
>
>
>
>So, leaving aside the instructions in the manual, how does one actually make
>the adjustment?
>
>Lying on my back with the wheel off and the car safely chocked up, I can
>slacken off the little nut (nut for cable per parts book) at the cables
>end. I then approach the bigger sleeve(?) nut on the cable. It will only
>rotate about > of a turn, taking the cable with it. My presumption (a
>dangerous thing) is this:
>
>The sleeve is supposed to rotate freely about the cable and that mine is,
>typically, jammed solid.
>
>Or, perhaps, it is 40+ years old and has no adjustment left in it, it being
>as tight as it will go.
>
>Any confirmations as to the above and suggestions would be well received.
>
>
>
>I imagine that replacing the cable is no an easy task??? I seem to recall
>the mention of various problems related to removal of handbrake levers etc?
>
>Thanks,
>
>Simon.
|