A pitman fork will work but you have to be VERY careful not to dent up
the steering box housing while you are pounding away at the end of the
fork....
On 5/3/08, Elton Schulz <eschulz@frontiernet.net> wrote:
> I found that a pitman puller works a lot better than a gear puller to get
> the steering arm off. The pitman puller is a lot sturdier.
> Elton
> BJ7 in progress
> ----- Original Message -----
> From: "John Kuzman" <jjkbj7@yahoo.com>
> To: <healeys@autox.team.net>
> Sent: Friday, May 02, 2008 7:51 AM
> Subject: [Healeys] Steering Arm Removal
>
>
> > I need some guidance on the removal of the steering arm from the
> > steering box on my BJ7. I am attempting to replace the seal.
> >
> > I removed the large nut and washer and soaked the joint with PB
> > Blaster for over a week. I attached a puller and tightened the puller
> > down to the point of almost deforming the puller and the arm has not
> > budged. I did not remove the steering side rods from the other end of
> > the steering arm. Do these need to come off to remove the arm from the
> > steering box splined shaft? Any other suggestions? Thanks.
> > _________________________________________________________________
> >
> > Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try
> > it now.
> > _______________________________________________
> > Support Team.Net http://www.team.net/donate.html
> >
> > Healeys@autox.team.net
> > http://autox.team.net/mailman/listinfo/healeys
> >
> > You are subscribed as eschulz@frontiernet.net
> >
> > http://www.team.net/archive
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>
--
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|