Or here:
http://search.harborfreight.com/cpisearch/web/search.do?keyword=pittman+arm+puller&Submit=Go
bs
Michael Salter wrote:
> A Pitman arm puller of the type shown on this page
> http://www.toolking.com/otc(divisionofspxcorp.)_otc7314a.aspx
> is ideal for the job, BUT you almost always have to use a protection nut and
> plate on the top of the thread.
> This is because the split pin holes in the shaft weaken that area so much
> that the pressure of the puller will crush the shaft.
> To prevent this I always leave the nut on the thread so that the end face of
> the nut is flush with the end of the shaft and then I put a piece of 1/4"
> thick steel over the end for the Pitman arm puller screw to press upon.
>
> Michael Salter
> 100 (1953)
> AHX12 (1953)
> Bugeye (1961)
> http://www.netbug.net/blogmichael/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|