healeys
[Top] [All Lists]

Re: [Healeys] O/D Installation

To: WILLIAM B LAWRENCE <ynotink@msn.com>, Kenny J <theswed@hotmail.com>,
Subject: Re: [Healeys] O/D Installation
From: David Nock <healeydoc@sbcglobal.net>
Date: Wed, 3 Sep 2008 08:08:12 -0700
.

On Sep 2, 2008, at 5:52 PM, WILLIAM B LAWRENCE wrote:

> Start the nuts on the long set pins and pull them down gradually  
> and evenly.
> If you encounter any resistance stop and check that the thrust  
> washers haven't
> shifted. Better to lose a little time than break the washers. Some  
> of them are
> getting hard to find. When the long pins bottom install the other  
> fasteners.



DO NOT DO THIS !!!!!!!!!!!!!

You should pull the overdrive together with two large channel lock  
pliers. If you can not pull it together by hand there is a miss  
alignment in side. I have sold many adaptor plates the people broke  
pull the overdrive together with the two long studs and nuts.




David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767

www.britishcarspecialists.com
.
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>