healeys
[Top] [All Lists]

Re: [Healeys] water pumps and other repro parts

To: Andy <sneddon@xsmail.com> (smtpout2.bornet.net [148.160.16.68]); Sun, 01 Mar 2015 11:43:35 +0100 (CET)
Subject: Re: [Healeys] water pumps and other repro parts
From: Magnus Karlsson <magnuskarlsson@bornet.net>
Date: Sun, 1 Mar 2015 11:43:30 +0100
Cc: "<healeys@autox.team.net>" <healeys@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <1D8056D04B4E476398BE6C72276E7E4E@WINDOWST93OFP9> <54F2A11E.4040305@cosmos.net.au> <D1DC80F3-F8F0-417A-BE70-C60183C02AE6@bornet.net> <000001d0540a$91fd09f0$b5f71dd0$@com>
To make such a listing sounds like a very good idea! 

Magnus Karlsson
www.concourshealeys.com

> 1 mar 2015 kl. 11:29 skrev Andy <sneddon@xsmail.com>:
> 
> Magnus raises a very valid point here re-the viability of companies selling
> less than adequate parts.  However I am sure that they "get away" with this
> because many of the orders they receive will be from folks who don't have
> the breadth of repeat usage experience that the specialist restorers have.
> i.e. they don't know that they are ordering poor quality parts.
> 
> From personal experience, receiving an order from one of the main (and I
> have tried quite a few!) is always a bit of a voyage of discovery and almost
> always results in receiving some parts which you are happy with the
> "quality", albeit finish, appearance etc and others where you feel are sub
> standard (rust breakthrough on new hubs, incorrect engine mounts, poor paint
> finish, being some I could mention). In my case this is even without having
> run the car yet - so no doubt some of the issues raised in this thread may
> appear.
> 
> I am not sure how it can be done, but there must be scope to collate the
> "experience" of the Healey Community into some form of guide or listing,
> highlighting the parts to be wary of and importantly either proven sources
> of the acceptable quality part / alternatives / solutions.  Perhaps in this
> way suppliers of the less that adequate parts would take notice.
> 
> Andy
> 
> -----Original Message-----
> From: Healeys [mailto:healeys-bounces@autox.team.net] On Behalf Of Magnus
> Karlsson
> Sent: 01 March 2015 09:18
> To: varley@cosmos.net.au
> Cc: healeys@autox.team.net
> Subject: Re: [Healeys] water pumps and other repro parts
> 
> Regarding the porous sumps, I pointed out this problem for the vendor
> several years ago and they still sell the same porous sumps. No attempts
> whatsoever at rectifying the problem. I have several examples of parts with
> serious faults known to the vendors, which they still pass on year after
> year. It's a policy hard to understand, which in the "normal" world most
> likely would lead to that company being outcompeted.
> 
> Magnus Karlsson
> www.concourshealeys.com
> 
>> 1 mar 2015 kl. 06:18 skrev Larry Varley <varley@cosmos.net.au>:
>> 
>> Hi Guys, it is in fact very disappointing the quality of some of the 
>> reproduction parts available for our cars. Whenever possible it is 
>> better to recondition original equipment rather than take the road 
>> that can seem easier by replacing. I have seen the following. New 
>> complete BJ8 steering box where the sector peg was fully soft steel 
>> and wore out in 2000 miles. Alloy petrol tanks that continually crack 
>> at the end seams. Plastic fuel gauge tank unit floats that crack at 
>> the clip that retains them. Ball joint boots that disintegrate 
>> quickly.  Cast aluminium 6 cylinder sumps that are porous and leak 
>> oil. Alloy 100 cylinder heads sold as for the 100 when they were in 
>> fact Austin A70 commercial heads with Healey valves fitted small deep 
>> combustion cambers and hopeless valve masking. And for goodness sake 
>> does anyone make a Healey exhaust mount that is properly vulcanised 
>> rubber to steel and doesn't fall apart? I know it is hard to make 
>> small volume production but in the real world the
> suppliers would be getting lots of warranty claims. My sample is just
> across 3 cars, so I'm sure there are more out there. Feel free to reply to
> the list with what parts have disappointed. While the list probably should
> not name and shame the suppliers, we should be pointing out what to be aware
> of when buying new reproduction parts. Wherever possible fix what the
> original manufacturer produced as it will have been made to a high standard,
> with repro, who knows.
>> Cheers
>> Larry Varley
>> 
>> 
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html Suggested annual 
>> donation  $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> 
>> Healeys@autox.team.net
>> http://autox.team.net/mailman/listinfo/healeys
>> 
>> Unsubscribe/Manage: 
>> http://autox.team.net/mailman/options/healeys/magnuskarlsson@bornet.ne
>> t
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html Suggested annual donation
> $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> 
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
> 
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/sneddon@xsmail.com
> 
> 
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2015.0.5645 / Virus Database: 4299/9203 - Release Date: 03/01/15
> 
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


<Prev in Thread] Current Thread [Next in Thread>