Thanks Reid. I just went out and bought it.
b
On Tue, 8 Aug 2000 12:25:01 -0700 "Simmons, Reid W"
<reid.w.simmons@intel.com> writes:
>
> Brad;
>
> 3M makes a spray-on glue for installing/repairing headliners. Auto
> parts
> stores and many hardware stores carry it. It comes in a LARGE spray
> can and
> you could probably do three cars with one can. I used it to fasten
> the heat
> shield material to the bottom side of the hood (bonnet).
>
> Reid
> '79 Spitfire (original owner)
>
>
> -----Original Message-----
> From: Bradley D Richardson [mailto:bradrichardson@juno.com]
> Sent: Tuesday, August 08, 2000 9:28 AM
> To: spitfires@autox.team.net
> Subject: adhesive
>
>
>
> Ok, I'm finally going to put the seat covers back on my Spit's
> seats.
> What adhesive should I use? Since it's form fitting, and since it
> was
> glued to the foam before I removed them, it's obvious I need some
> kind of
> glue. I tried contact cement, it doesn't hold at all to the foam.
>
> On another thought, the headliner in my daily driver is drooping?
> Obviously, it needs to be glued again also. Other than removing the
> entire stinking headliner, is there some kind of gizmo that will let
> me
> shoot the glue thru a small 'pin hole' in the liner?
>
> Brad
>
> ====================================================
>
> Brad Richardson
> Portland, Oregon
> 79 Spitfire (FM90541U, really a 78 as made June 78)
> 79 Spitfire (TFZDW29T001453, really a 80 as made Nov 79)
> ________________________________________________________________
> http://dl.www.juno.com/get/tagj.
>
________________________________________________________________
http://dl.www.juno.com/get/tagj.
|