spridgets
[Top] [All Lists]

RE: rear seal

To: Ulix Goettsch <ulix@u.washington.edu>
Subject: RE: rear seal
From: robert weeks <robert@woozy.com>
Date: Fri, 19 Feb 1999 19:35:05 -0500
Cc: "'Spridgets@Autox.Team.Net'" <Spridgets@autox.team.net>
In-reply-to: <Pine.OSF.4.05.9902191619120.15096-100000@saul9.u.washington.edu>
References: <v0300780cb2f3a8cd1b05@[152.16.66.163]>
Reply-to: robert weeks <robert@woozy.com>
Sender: owner-spridgets@autox.team.net
Would that work? I thought they had to be oriented right side up? Doesn't
gravity have something to do with the resting place of the little weighted
inner piece on a modern type PCV valve? I'll put it where ever it will work
best.

I have a friend who said he'll lend me his new garage and a hand tomorrow,
hopefully well get this straightened out.

Thanks,

Robert


>On Fri, 19 Feb 1999, robert weeks wrote:
>
>> If I drill and tap the Weber manifold to add a PCV valve does it matter
>> which side of the U shaped manifold I do it to? It's either got to be on
>> the #1 - #2 side or the #3 - #4 side.
>
>Are you sure you couldn't mount it centered under the carb, that would be
>better.
>
>Then plumb the PCV valve to the front cover or the front cover and the
>valve cover.
>
>    Ulix                                       __/__,__      ___/__|\__
>..............................................(_o____o_)....<_O_____O_/...
>                                              '67 Sprite     '74 X1/9




<Prev in Thread] Current Thread [Next in Thread>