spridgets
[Top] [All Lists]

Re: Quarter Panel Beading

To: "Leo S." <ldsp@flash.net>, "Ulix Goettsch" <ulix@u.washington.edu>
Subject: Re: Quarter Panel Beading
From: "Jay Bourgraf" <jaybird@isoc.net>
Date: Wed, 10 Mar 1999 22:33:48 -0500
Cc: "Spridgets" <spridgets@autox.team.net>
Reply-to: "Jay Bourgraf" <jaybird@isoc.net>
Sender: owner-spridgets@autox.team.net
Thanks for all of the responses. Sounds like leaving the seam intact
and replacing the top of the "t" is the way to go. I just couldn't see
drilling all those holes in that seam. On the inside, the seams are
just mint. I could never duplicate the structural integrity of the
seam unless I had a spotwelder to put it back together. Thanks again.


<Prev in Thread] Current Thread [Next in Thread>