Hi Bob
I usually strive for the lowest value, I have in the past bought sets of
thrust washers in the standard, +0.005 and +0.010 sizes and mixed and
matched them to reduce the end float to the minimum, say using one from a
standard and one from the +.005 this would be approx equal to +0.0025.
HTH Graham.
----- Original Message -----
From: "bob" <rmf3860@erols.com>
To: "six pack" <6pack@autox.team.net>; <triumphs@autox.team.net>
Sent: Thursday, January 03, 2002 3:23 PM
Subject: Resoration & Questions Begin-#1
| List:
| 2. I measured the crankshaft play with a dial indicator and it showed
| .010. Should I strive for the lowest end of the normal range (.006-.008)
| or right in the middle when buying an oversize thrust bearing?
| That's all for now. Hope the questions aren't too long. Thanks for any
| information you can give me.
|
| Bob Fabie
| '75 TR6
|
---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.313 / Virus Database: 174 - Release Date: 02/01/02
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|