Paul: The critical point in alignment is your door posts. As long as you
have them
stabilized., align from there, if you must drill holes, they may be used as
spot weld locations where possible.
Bob Roberts
TR$----- Original Message -----
From "Paul Dorsey" <dorpaul at negia.net>
To: "triumph list" <triumphs@autox.team.net>
Sent: Monday, November 15, 2004 9:17 PM
Subject: installing TR3 floorpan
> As you may know, I am putting new floorpans and sills in my TR3A. I am
> trying
> to do it the right way and installing one panel at a time so as retain
> maximum
> rigidity and reference points. As halfway expected, the new floorpan
> didn't
> exactly line up the old inner seal supports. When it comes time to
> install
> the new inner and outer sills, should I adjust the new sill slightly
> front-to-back so as to align the sill support with the floorpan? I guess
> the
> alternative is to drill holes in the floorpan.
> Thanks,
> Paul Dorsey
> 60 TR3A
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
|