I replaced my square 7/16th "outie" with an 8 mm hex recessed one, you might
try that if it is a hex head.
Tom
----- Original Message -----
From: "Andrew Frink" <tr4@drooartz.com>
To: "triumphs" <triumphs@autox.team.net>
Sent: Thursday, September 01, 2005 11:57 AM
Subject: Transmission check plug -- what size?
> The plug on the side of the tranny used for filling is a recessed
> square drive plug. How annoying. What size is this? It looked like a
> 3/8", but that didn't seem to work--slightly too big. I don't have
> any good measuring devices for something that small. Would this be
> standard size, or metric?
>
> I'll replace this with an "outy" plug listed in Moss so I can use the
> nice square wrench I got from Joe, but I do need to get it off first!
|