>> The hole for top heater mounting stud, also used to anchor brake
>> line, seems
>> way too big for the mounting stud. Am I right in guessing that a rubber
>> grommet goes in the hole prior to installing the heater bracket?
>
> Not on TS39781LO. The hole is just the right size for the stud, no room
> for
> a grommet. Are you sure you're not looking at the hole for the oil
> pressure
> tube ?
>
> Randall
No, there are only three in a row there, and the one left of the oil
pressure tube is much too big for the stud. Is it possible that since the
body guy replaced the batterybox, the old hole was covered and the new one
the wrong size?
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|