Dear Listers,
I remember reading on the list that the splines of the propshaft need to be
engaged so the yokes (attached to the universals) of the propshaft are lying
in the same plane. Is this correct?
I have just discovered that mine are about 30deg out of synch and the car
has a bit of a vibration from down under. Could this be the problem and is
it possible to set right from under the car? The prop shaft runs above the
'T shirt" reinforcing plate with standard exhaust.
Thanks for any advice in adv.
Regards
Chris Buckley
--
This message has been scanned for viruses and
dangerous content by Africa Online Tanzania, and is
believed to be clean.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|