Hello all, I am another very happy customer of Chevy Duty. There service has been great, they offer more of what I am usually looking for and have good prices. Anyone of us can have a specific proble
Hi Claude, That is a nice looking bumper. I have a '58 Fleetside with a pretty heavy diamond plate bumper that I have towed other vehicles with. It is strong but very ugly. What was the cost and is i
I have my '58 Fleetside for sale and also some nice Advance Design parts. The pickup is a long-bed with 3-speed Saginaw overdrive, recently rebuilt 261,front disc/power/dual master brakes, electric
Following the recent thread on the various harnesses available, I would like to announce that I have a Painles Pickup and 4x4 brand new in the box 18 circuit harness that I will not be using. I paid
I have a U.S. Radiator never removed from its foam packed box for sale. It is for Task Force Trucks (55 2nd-59) and has a built in trans cooler section. I need to sell the truck it was destined for t
I have a front and rear set of sway bars, new in box, for sale. They are for Task Force Trucks (55 2nd-59). They are complete kits with bushings, etc. I purchased them on sale through Brothers and pa
Life has taken a few unexpected turns. This prompts the need to sell my '58 Fleetside long-bed. The condition is a bit rough on the outside but I have made several mechanical improvements. I will tak
Hi Paul, I made a bushing pusher with a long bolt that just fits through the bushing, some washers, a nut and some short sections of galvanized pipe. You need one piece of pipe big enough for the bus
I used TIP Tools diagram as a guide to my plumbing and am very happy with it. My compressor (Quincy 2-stage 5 hp) is about 20' from my shop on a small slap attached to my building. I built a vented e
Hi Dave, You have a great web site and your work is beautiful! Can you tell us just how you printed your interior decals? What type of paper did you use? Was it self-adhesive? I have not seen this do
I have two original Advance Design 16" wheels with hub cap clips in place. They are in great shape and for sale. Can anyone tell me the value of these wheels? I also have a rear splash apron in very
Hi Jack and list, I tried replying to your email to me and had the address rejected. If you are interested in the rear splash apron, I am asking $150. It is very straight with some minor surface rust
Regarding the undercoat, I used a heat gun and then wooden tool I shaped like a gasket scraper. This took time but removed most of the undercoat without damaging the paint below it. I used lacquer th
Sears sells square sockets. I have the few that are needed for these trucks and find them very handy. Stephen buy I The frame <oletrucks@autox.team.net> stupid questions get gearing. oletrucks is dev
Your are correct. No one makes repro grills for those two years. I have a '58 Fleetside for which I found a used grill in pretty good shape. I have only seen one other in decent shape and it was boug
That compressor will be working most of the time if you try to use it for sandblasting. It will probably do fine for HVLP painting if you have a good spray gun. I have a Quincy two-stage with an 80 g
That compressor will be working most of the time if you try to use it for sandblasting. It will probably do fine for HVLP painting if you have a good spray gun. I have a Quincy two-stage with an 80 g
Hi Bob, You have one of the greatest trucks ever made. I have parted out a '49 GMC Panel. I have the fenders for sale which are pretty straight. I also have other items on my web site: https://www.hu