- 1. Hydraulic Line for CLutch (score: 1)
- Author: Unknown
- Date: Tue, 23 Oct 2001 13:36:27 -0700 (PDT)
- I just discovered that some previous owner of #72588, a '68 Sprite, for some reason or another removed the hydraulic line running between the Clutch Master and the Clutch Slave Sylinder when the engi
- /html/spridgets/2001-10/msg00987.html (7,006 bytes)
- 2. Re: Hydraulic Line for CLutch (score: 1)
- Author: Unknown
- Date: Tue, 23 Oct 2001 15:59:06 -0500
- 55 inches long 1/4" pipe, double flare, 7/16-20 male pipe nuts each end. Runs from the hose bracket on the left side frame rail near the slave, up along the right footwell, across the bulkhead behind
- /html/spridgets/2001-10/msg00991.html (7,740 bytes)
- 3. Re: Hydraulic Line for CLutch (score: 1)
- Author: Unknown
- Date: Tue, 23 Oct 2001 17:26:01 EDT
- Jim: If you don't use a flexible section of line between the master and the slave, put a loop in the line. That way it will flex instead of bend when the engine torques. The bending will eventually b
- /html/spridgets/2001-10/msg00995.html (6,835 bytes)
- 4. Re: Hydraulic Line for CLutch (score: 1)
- Author: Unknown
- Date: Tue, 23 Oct 2001 17:23:50 -0700
- As I recall, you'll need about 52-54". I have one I can measure for you later. Gerard -- Please visit Four Points Travel - Discount Online International Travel Reservations http://www.gerardsgarage.
- /html/spridgets/2001-10/msg00999.html (7,856 bytes)
This search system is powered by
Namazu