Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*missing\s+oil\s+seal\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*missing\s+oil\s+seal\s*$/: 6 ]

Total 6 documents matching your query.

1. missing oil seal (score: 1): Author: John Cave <cavej@mcmaster.ca>; Date: Fri, 17 Nov 2000 13:28:44 -0500; I,m replacing a won out bearing in the rear extension of my 1500 transmission, while i,m down this far i thought i,d replace all the seals and bearings, Rimmer,s shows an oil seal between the bell ho; /html/spitfires/2000-11/msg00281.html (7,111 bytes)
2. Re: missing oil seal (score: 1): Author: Joe Curry <spitlist@gte.net>; Date: Fri, 17 Nov 2000 11:31:59 -0700; How old is that bell housing? There were two different front covers used. The early ones have a scroll type seal as you describe. THe later ones have the means of adding a modern type of seal. If yo; /html/spitfires/2000-11/msg00282.html (7,613 bytes)
3. Re: missing oil seal (score: 1): Author: "Bob Harris" <gharris@rochester.rr.com>; Date: Fri, 17 Nov 2000 16:28:22 -0500; John& Joe Is this an overcrive trans? I've read and from what I've seen (2 od transmissions) the overdrive trans was fitted with the scroll seal through 1980. I believe I read it in the Rimmer cat. w; /html/spitfires/2000-11/msg00284.html (7,271 bytes)
4. RE: missing oil seal (score: 1): Author: "Graziano, Michael" <michael.graziano@csfb.com>; Date: Fri, 17 Nov 2000 16:56:48 -0500; Spoke to my tranny guy about these. His opinion was that they're not necessary. Michael John& Joe Is this an overcrive trans? I've read and from what I've seen (2 od transmissions) the overdrive tran; /html/spitfires/2000-11/msg00286.html (8,767 bytes)
5. Re: missing oil seal (score: 1): Author: Joe Curry <spitlist@gte.net>; Date: Fri, 17 Nov 2000 16:04:00 -0700; I am not all that familiar with the single rail gearbox (don't have any but have sold a couple of them), so I can't comment on the front seal or the lack of thrust washer springs on that unit. Howev; /html/spitfires/2000-11/msg00287.html (7,823 bytes)
6. Re: missing oil seal (score: 1): Author: John Cave <cavej@mcmaster.ca>; Date: Mon, 20 Nov 2000 12:22:37 -0500; Thanks everyone, it wasn,t leaking before i split the bell housing, so i,ll put it back together and hope Murphy is,nt looking. cheers john cave; /html/spitfires/2000-11/msg00319.html (8,243 bytes)

Current List: 1 - 6
Page: [1]