While wrestling with my oil filter housing, before admitting defeat, I
managed to knock off a few electrical connections. One of them was the
Brake failure switch. Well the switch seems to have 2 pins, yet the
connector has only 1. One of the pins is fat and the other is skinny. The
schematics seem to show a connection to this switch and a ground connection.
I am thinking that the switch is already grounded by virtue of being screwed
into its socket in the brake system, which is attached to the body/frame.
Any hints here will be appreciated.
Regards,
John Cyg
CC52927LO
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|