John,
We did mine a while back...it's pretty much welded
from where you see. You should be able to grind off
the edges. You may have to chisel some, but it
shouldn't give you too much trouble. Mine needed some
of the frame rail sections replaced.
You should NOT need any frame jigs, but if you want to
make sure it doesn't move weld some angle iron across
the frame rail sections.
I believe Moss carries the replacement sections or CTM
Engineering(UK).
Good Luck
Todd Bermudez
CD198L
CF25768UO
--- John Mitchell <jmitch@snet.net> wrote:
> I was replacing steel brake lines on the TR6
> today and noticed a
> rust bubble on the lower t-shirt metal. I picked it
> open with a
> screwdriver and theres no corrosion on the frame
> rail and the rest looks
> good top and bottom. The upper also seems fine as
> best I can tell with
> the body on.(Engine and Tranny out) Is the T-shirt
> able to be removed
> and a new panel welded on without jigs or a frame
> machine? Are there
> weld above or just the welds I see from below.
> Seems like you knock
> off one project and another one's staring you in the
> face:( John
> Mitchell 76 TR6
>
__________________________________
Yahoo! Mail
Stay connected, organized, and protected. Take the tour:
http://tour.mail.yahoo.com/mailtour.html
|