alpines
[Top] [All Lists]

Re: [Alpines] Clutch compatibility

To: awtiger@cox.net, alpines@autox.team.net
Subject: Re: [Alpines] Clutch compatibility
From: JACranwell@aol.com
Date: Tue, 8 Jan 2008 12:54:36 EST
Andy,

I believe you need to match the master and slave cylinders to the clutch 
cover/pressure plate.

To SIII had the heavy spring type, and SV the lighter diaphragm type. The 
travel will be different, and would therefore need to match the cylinders. It 
may 
be only the master that would be different. The manual shows a different type 
of master used from the SIV onwards, P/N 7293, the older type shown as P/N 
5461. There is no difference shown for the slave.

The clutch plate itself also differs, but you must have this covered, as it 
is determined by the differing splines on the gearbox input shaft.

FYI, I'm using all SV parts, including the gearbox, clutch and cylinders in 
my SIII, and all works very well.

Good luck,

Julian.   
_______________________________________________
Support Team.Net  http://www.team.net/donate.html

Alpines@autox.team.net
http://autox.team.net/mailman/listinfo/alpines

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>